Installing Cover For Rear Underbody
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws and nuts using > Nr.89 Pos.5 - torque screwdriver .
Screw in screws and tighten to > Tightening torque 3 (2 ftlb.) Nm .
Screw on nut and tighten to > Tightening torque 2 (1.5 ftlb.) Nm .
Screw on nut and tighten to > Tightening torque 2 (1.5 ftlb.) Nm .
Screw in screws and tighten to > Tightening torque 2 (1.5 ftlb.) Nm .
Screw in screws and tighten to > Tightening torque 3 (2 ftlb.) Nm .
Screw in screws and tighten to > Tightening torque 2 (1.5 ftlb.) Nm .