Installing Cover For Centre Underbody
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Information
Micro-self-locking screw
Fit new screw following removal.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws and nuts using > Nr.89 Pos.5 - torque screwdriver .
Tighten screws -2- to > Tightening torque 3 (2 ftlb.) Nm .
Tighten screw -3- to > Tightening torque 3 (2 ftlb.) Nm .
Tighten nuts -1- to > Tightening torque 2 (1.5 ftlb.) Nm .
Cover for centre underbody