Removing Front Cover

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Components not fitted when engine is running or during test drive

Risk of damage to components due to reduced cooling performance
Before starting the engine, make sure that all air-supply components are completely fitted.
Only start the engine when the heat shields and design cover are fitted.
Only test-drive the vehicle when all underbody panelling, heat shields and the design cover are fitted.

Information

The number of screws, clips, electric plug connections, holders and trim panels can vary depending on equipment.
The illustrations for removing and installing are shown only on one equipment variant and can differ from the actual equipment variant.
Some steps must be carried out automatically.

Remove front section of front underbody cover -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front section of front cover
1. 1.1 Unscrew fastening screws -1 and 2- .
2. 1.2 Remove front section of front underbody cover -3- .
Remove rear section of front underbody cover -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear section of front cover
1. 2.1 Unscrew fastening screws
2. 2.2 Remove rear section of front underbody cover -2- .
Remove side section of front underbody cover -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fastening screws for cover
1. 3.1 Unscrew fastening screws -2- .
2. 3.2 Remove side section of front underbody cover -3- .