Information On Applying Adhesive After Body Repairs

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

The following illustrations are intended as a guide if there is no longer a complete layer of adhesive residue.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive at the front side

1	Inner adhesive bead (parallel to cut edge -3- and centred on reinforcement)
2	Outer adhesive bead (parallel to and tight against cut edge -3- )
3	Cut edge

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive at the front

1	Outer adhesive bead (parallel to and tight against front indentation -3- )
2	Inner adhesive bead (parallel to cut edge -4- and tight against rear indentation -3- )
3	Indentations
4	Cut edge

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive at the rear side

1	Adhesive bead (centred on reinforcement and parallel to cut edge -2- )
2	Cut edge
3	Changeover position of adhesive bead (when there is a contour step in the bodyshell)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Applying adhesive at the rear

1	Inner adhesive bead (parallel to indentation -4- and tight against indentation -5- )
2	Outer adhesive bead (parallel to indentation -6- )
3	Ventilation area
4	Indentation
5	Indentation
6	Indentation