LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (55 - Lids, Flaps 9YA) >> WM, 557319 Removing And Installing Actuating Cylinder For Rear Lid >> Removing Actuating Cylinder For Rear Lid

Removing Actuating Cylinder For Rear Lid

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Incorrect handling of actuating cylinders
  • Actuating cylinders can burst
  • Risk of eye injuries
  • Risk of bruising
    • The actuating cylinders must be in idle state in order to remove them.
    • Open the lid fully.
    • Ensure the end position of the lid manually.
    • Secure the lid after removing the actuating cylinders to prevent it from closing accidentally.
    • Do not use force when opening the actuating cylinders due to the high internal pressure.
IMPORTANT: The help of another person is required to prevent the rear lid from closing accidentally.
  1. Release and disconnect electric plug connection -1-  .
    G14277283Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric plug connection

  2. Unclip electric line from holder -2-  .
    G14277284Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric line

  3. Loosen rubber sleeve -1-  and guide out electric wire harness.
    G14277285Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rubber sleeve

  4. Release safety clips -1-  using a suitable tool.
    G14277286Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Safety clips

  5. Pull actuating cylinder for rear lid -1-  off the ball pin -2-  (-Arrow-)  and remove it.
    G14277287Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Actuating cylinder for rear lid

scientia non olet · About LEMON Manuals