Removing Side Section Flap (Module)

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: The side section flap module will be damaged during removal and must be replaced during installation.

Loosen emergency release > Emergency release on the fuse box.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Emergency release
1. 1.1 Remove cover on fuse box.
2. 1.2 Unclip emergency release latch (cable) on the fuse box -Arrow- .
Open side section flap.
Loosen side section flap -arrows- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Side panel flap (module)
1. 3.1 At the marked positions -arrows- , pierce the module using a screwdriver.
Loosen side section flap > Side panel flap (module).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Side panel flap (module)
1. 4.1 Pierce the module using a screwdriver -arrow A-.
2. 4.2 Release locking lugs on inner part of side section flap (module) -arrow B- .
Remove side section flap (module) > Side panel flap (module).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Side panel flap (module)
1. 5.1 Swivel side section flap (module) > Side panel flap (module) out of the body aperture until the electric plug connections -1 and 2- are accessible.
2. 5.2 Release and unplug electric plug connections -1 and 2-.
3. 5.3 Pull drain hose -3- off the side section flap (module) > Side pane flap (module).
4. 5.4 Remove side section flap (module) > Side pane flap (module).
Remove actuator -1- and charging operator control unit -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing actuator and charging operator control unit
1. 6.1 Unclip actuator -6- and charging operator control unit -2- (-Arrows-) .
2. 6.2 Remove actuator -1- and charging operator control unit -2- .