LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (55 - Lids, Flaps 9YA) >> WM, 551419 Removing And Installing Operating Cable For Front Lid Lock >> Removing Operating Cable For Front Lid Lock

Removing Operating Cable For Front Lid Lock

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • The number of fastening screws, fixing clips, plug connections, holders and trim panels can vary depending on equipment. 
  • The illustrations for removing and installing the drive mechanism are shown only on one equipment variant and may differ from the actual equipment variant. 
  • Some steps must be carried out automatically. 
  • Some of the repair illustrations show only one side of the vehicle. 
  1. Unscrew screws -1-  and remove release element -2-  .
    G14277205Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Screws and release element

  2. Unclip cover -1-  .
    G14277206Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Cover

  3. Unclip operating cable -1-  from coupling housing.
    G14277207Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Operating cable

  4. Unclip deflection unit -1-  on the lock carrier.
    G14277208Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Deflection unit

scientia non olet · About LEMON Manuals