Preparing Side Section Lower Part For Installation

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Countersunk head of the flow-form rivets must be pointing inwards. Observe the required punch and joining direction.

IMPORTANT: Also drill through the underlying con ponent in order to ensure adequate clearance for blind rivets.

Fit in side section lower part and secure it to the body.
Drill bore holes for blind rivets -1- through both sheetmetal panels.
Diameter 6, mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore holes
Drill bore holes for blind rivets -3- through all sheetmetal panels.
Diameter 7, mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bore holes
Punch holes for flow-form rivets -2- .
5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Holes for flow-form rivets
Remove side section lower part.
Prepare the marked areas on the outside for bonding and riveting.
5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing outside of component
Prepare the marked areas on the inside for bonding and riveting.
5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE PAH.071.781.00

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Preparing inside of component