LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (53 - Body Rear 9YA) >> WM, 53485505 Replacing Rear Side Member (Section) >> Subsequent Work >> Subsequent Work For Body Repairs (With Straightening System)

Subsequent Work For Body Repairs (With Straightening System)

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove vehicle from the straightening system.
  2. Clean joint areas and sheetmetal flanges with a wire brush.
  3. Prime joint areas and sheetmetal flanges with 2K primer.
  4. Restore standard seal with body sealant

    5X00IN42 Seam sealing

    Also seal the repair area carefully.

  5. Paint repair area and adjacent surfaces, if necessary.
  6. Restore standard underbody protection with underbody sealant

    5X00IN43 UNDERBODY PROTECTION

  7. Apply standard cavity preservation

    5X00IN44 CAVITY PRESERVATION

    Also carefully apply cavity preservation to the repair area.

  8. Install removed accessories in the repair area.
scientia non olet · About LEMON Manuals