Installing Lock Carrier

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Install lock carrier and check that it fits perfectly.
Damaged side:
Apply adhesive on the joint area Areas for adhesive of the body. Application depth 0.5 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Areas for adhesive
Damaged side:
Apply adhesive on the lock carrier Areas for bonding . Application depth 0.5 mm

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Areas for bonding
1. 3.1 Also apply a bead of adhesive all around the bonding surface. Application depth 3 mm
Remaining preparation as described in Workshop Service Information.
530955 REPLACING LOCK CARRIER - SECTION ON "INSTALLING"
Damaged side:
Set blind rivets.

Areas -A- : BLIND RIVETS 999.190.229.01

Areas -B- : BLIND RIVETS 999.190.227.01

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Blind rivets
Damaged side:
Screw in self-tapping screw -1-

5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Self-tapping screw
Remaining preparation as described in Workshop Service Information.
530955 REPLACING LOCK CARRIER - SECTION ON "INSTALLING"
1. Install D-pillar reinforcement (section).
  53305505 REPLACING D-PILLAR REINFORCEMENT (SECTION) - SECTION ON "INSTALLING"
2. Install rear side section.
  535555 REPLACING REAR SIDE SECTION - SECTION ON "INSTALLING"