Installing Seat Cross Member

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

Apply adhesive evenly over the entire bonding surface.

IMPORTANT:

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Fit in seat cross member and secure it to the body.
Apply adhesive on joint areas Joint areas of the body. Application depth 0.5 mm
Use body structural adhesive.

5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Joint areas
Apply adhesive in the marked areas Bonding areas on the seat cross member. Application depth 0.5 mm
Use body structural adhesive.

5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Bonding areas
1. 3.1 Also apply a bead of adhesive all around the bonding surface. Application depth 3 mm
Rivet in seat cross member Rivet area . BLIND RIVET 999.190.229.01

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rivet area
Screw in self-tapping screws -1- .
5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Self-tapping screws