Installing Rear Boot Floor Plate
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Install rear boot floor plate and check that it fits perfectly.
- Apply adhesive on the joint area Joint area for adhesive
of the body. Application depth 0.5 mm
5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE
Joint area for adhesive
- Apply adhesive on the joint area Joint area for adhesive
of the body. Application depth 0.5 mm
5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE
Joint area for adhesive
- Apply adhesive on rear boot floor plate Bonding areas
. Application depth 0.5 mm
Bonding areas
- 4.1 Also apply an adhesive bead of sealant all around the bonding surface. Application depth 3 mm
- Apply adhesive on rear boot floor plate Bonding areas
. Application depth 0.5 mm
Bonding areas
- 5.1 Also apply an adhesive bead of sealant all around the bonding surface. Application depth 3 mm
- Set blind rivets in areas -A-
. BLIND RIVETS 999.190.227.01
Blind rivets, bottom 7 Set blind rivets Blind rivets, inner . BLIND RIVETS 999.190.227.01
Blind rivets, inner
- Screw in self-tapping screws -1-
.
5X00IN24 SETTING SELF-TAPPING SCREWS
Self-tapping screws, inner
- Screw in self-tapping screws
5X00IN24 SETTING SELF-TAPPING SCREWS
Self-tapping screws, lower