LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (53 - Body Rear 9YA) >> WM, 530555 Replacing Rear Closing Panel >> Preparing Rear Closing Panel For Installation

Preparing Rear Closing Panel For Installation

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
  • The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
  • Do not begin bonding work until all materials and tools necessary for later repair work are available.
  1. Fit in rear closing panel and secure it to the body.
  2. Drill bore holes Bore holes for blind rivets  for rivets through both sheet-metal panels. Diameter 6.6 mm 
    G14276103Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Bore holes for blind rivets

  3. Punch holes Holes for flow-form rivets  for flow-form rivets.

    5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS

    G14276104Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Holes for flow-form rivets

  4. Remove rear closing panel.
  5. Prepare marked areas Rear closing panel  for bonding and riveting.

    5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

    G14276105Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rear closing panel

scientia non olet · About LEMON Manuals