LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (50 - Body Front 9YA) >> WM, 505319 Removing And Installing Wing Connection Panel >> Installing Front And Rear Wing Connection Panel

Installing Front And Rear Wing Connection Panel

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position front and rear wing connection panel -1-  on the wing.
    G14274520Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front and rear wing connection panel

  2. Screw in screws -2-  , but do not tighten.
    G14274521Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Screws

  3. Install front and rear wing connection panel -1-  together with the front wing -2-  .
    G14274522Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front and rear wing connection panel

  4. Screw in screws -3-  as far as required until the front and rear wing connection panels -1-  can still be moved.
    G14274523Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Front and rear wing connection panel

  5. Check gap dimensions of wing and make adjustments if necessary.

    5X00IN Gap dimensions

  6. Remove front wing from front and rear wing connection panel.
  7. Tighten screws -3-  to > Tightening torque 10 N.m (7.5 ft.lb)  > Tightening torque 10 N.m (7.5 ft.lb)  .
    G14274524Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Screws

  8. Clip in electric wire harness -1-  (-2-  ).
    G14274525Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric wire harness

  9. Install pressure sensor -2-  and tighten screw -1-  to > Tightening torque 8 N.m (6 ft.lb)  .
    G14274526Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Pressure sensor

scientia non olet · About LEMON Manuals