Installing Lock Carrier
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Installation is performed in reverse order. Pay particular attention to the following:
- Tighten fastening screws on the upper lock carrier to > Tightening torque 8 N.m (6 ft.lb)
according to the specified tightening sequence > Tightening sequence.
Tightening sequence
- Tighten fastening screws on lower lock carrier to > Tightening torque 23 N.m (17 ft.lb) .
- Tighten fastening screw securing refrigerant lines to condenser to > Tightening torque 9 N.m (6.5 ft.lb) .