Removing Lock Carrier
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Refrigerant
- Danger of freezing
- Avoid contact with refrigerant.
- Wear personal protective gear.
- Observe the safety regulations for working on air-conditioned vehicles and handling refrigerant.
- Observe the safety regulations for extraction and filling systems.
- Observe the instructions for repairing air-conditioning systems and storing spare parts.
WARNING:
Hot fluid
- Danger of scalding
- Avoid contact with hot fluid.
- Wear personal protective gear.
IMPORTANT:
When removing the refrigerant lines:
Close off all refrigerant lines and connections using suitable stoppers.
Check O-rings on the refrigerant lines for damage and replace them if necessary.
Close off all refrigerant lines and connections using suitable stoppers.
Check O-rings on the refrigerant lines for damage and replace them if necessary.
Information
When installing the refrigerant lines:
Wet the O-rings of the refrigerant lines with refrigerant oil.
Do not remove the stoppers for the refrigerant lines and connections until shortly before installation.
IMPORTANT:
After disconnecting hoses, close off all openings immediately using commercially available rubber stoppers.
When fitting parts, do not remove stoppers until shortly before installation.
When fitting parts, do not remove stoppers until shortly before installation.
IMPORTANT:
The help of another person is required.
- Release lock on coolant overflow line -1-
and pull it off the radiator.
Coolant overflow line
- Unclip coolant overflow line -2-
from retaining clips -3-
.
Coolant overflow line
- Release safety clip on coolant line -1-
and pull coolant line -2-
off the radiator.
Coolant line
- Release and unplug electric plug connections -3-
.
Electric plug connections
- Unscrew fastening screw -1-
and pull off refrigerant lines -2-
.
Refrigerant lines
- Release safety clip on coolant line -1-
and pull coolant line -2-
off the radiator.
Coolant line
- Release and disconnect electric plug connections at the left -1 and 2-
.
Electric plug connections at the left
- Unclip line bracket -3-
and move electric wire harness towards the centre of the vehicle.
Line bracket
- Release and disconnect electric plug connections at the right -1, 2 and 3-
.
Electric plug connections on the right
- Unclip line bracket -4- and move electric wire harness towards the centre of the vehicle.
Line bracket
- Remove operating cable for front lid lock.
551419 REMOVING AND INSTALLING OPERATING CABLE FOR FRONT LID LOCK
- Unscrew fastening screws -1 and 2-
.
Lower lock carrier
- Unscrew fastening screws -1-
and remove lock carrier -2-
.
Fastening screws