LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (5X - Body General 9YA) >> WM, 5X00IN22 Working With Body Foam Filler >> Working With Body Foam Filler >> Joining Process

Joining Process

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Use foam filler within the processing time. 
  • Do not apply pressure on foam-filled parts until hardening is complete. 
  1. Remove seal on the activation lid.
  2. Use a piece of wire to pull the activation lid out as far as it will go (approx. 11 cm up to the notch).
  3. Break off the wire at the required rupture point (notch) over the valve.
  4. Screw plastic adapter into the valve.
  5. Shake can vigorously up and down (approx. 20 times).
  6. Release foam downwards out of the can with the valve.
scientia non olet · About LEMON Manuals