LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (5X - Body General 9YA) >> WM, 5X00IN22 Working With Body Foam Filler >> Working With Body Foam Filler >> Assembly And Endurance Strength

Assembly And Endurance Strength

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • The object temperature must be above the minimum hardening temperature for the entire specified time period. 
  • If the minimum hardening temperature could not be reached within the specified time period, the standing time must be increased or additional heat must be applied to the bonded joint. 
  • If the hardening temperature is significantly less than the minimum hardening temperature, this can cause irreversible damage to the bonded joint. This will have a negative effect on the strength of the bonded joint. 

Following repair bonding, the vehicle must not be moved, no further work must be carried out and the vehicle must not be handed over to the customer for at least > Hardening time at 28°C 3 h  and > Hardening time at 15°C 5 h  .

scientia non olet · About LEMON Manuals