Working With Body Structural Adhesive Pah.071.781.00: Hardening
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
The body structural adhesive used hardens at temperatures of between > Minimum temperature 18°C and > Maximum temperature 80°C . Hardening can be accelerated by heat (e.g. using an infrared heater
IMPORTANT:
Infrared heaters only heat small sections of the body and are therefore only suitable for minor repairs.
- Only use devices with temperature control, automatic distance measurement and measuring point display.
or in a painting booth).
Do not put pressure on bonded parts until the required assembly strength is reached.