LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (63 - Bumpers -- Cayenne 9YB) >> WM, 63571930 Removing And Installing Rear Retaining Strip >> Removing Rear Retaining Strip >> Removing Centre Retaining Strip

Removing Centre Retaining Strip

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Voltage peaks
  • Risk of damage to electrical load or to the control unit

→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
→ Switch off electrical loads before disconnecting or removing them.
  1. Remove control unit for garage door opener -2-  .
    G14349508Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric plug connection

    1. 1.1  Release and unplug electric plug connection -1-  .
    2. 1.2  Release locking lug -3-  and remove control unit for garage door opener -2-  .
  2. Disconnect wire harness -1-  .
    G14349509Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Wire harness

    1. 2.1  Unclip clips -2-  and disconnect wire harness -1-  .
  3. Remove centre retaining strip -1-  .
    G14349510Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Centre retaining strip

    1. 3.1  Unscrew nuts -2-  .
    2. 3.2  Remove centre retaining strip -1-  .
scientia non olet · About LEMON Manuals