Preparing The Body For Installing The Rear Side Panel

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information

Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
Do not begin bonding work until all materials and tools necessary for later repair work are available.

Tack on sheetmetal insert used as welding backing strip on the body. > Sheetmetal insert

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sheetmetal insert