Installing Cross Panel (Upper Section)
WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten screws securing cross panel (upper section) to bracket to > Tightening torque 10 (7.5 ftlb.) Nm .
Tighten spring nuts securing heat shield to cross panel (upper section) to > Tightening torque 2.5 (1.75 ftlb.) Nm.
Tighten nuts securing external power connection to bracket to > Tightening torque 3 (2 ftlb.) Nm.
Tighten nut securing power distributor at the front to external power connection to > Tightening torque 9 (6.5 ftlb.) Nm.