Installing Front And Rear Wing Connection Panel

WARNING: This page is about a different car, the 2021 Porsche Cayenne and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Position front and rear wing connection panel -1- on the wing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front and rear wing connection panel
Screw in screws -2- , but do not tighten.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws
Install front and rear wing connection panel -1- together with the front wing -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front and rear wing connection panel
Screw in screws -3- as far as required until the front and rear wing connection panels -1- can still be moved.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front and rear wing connection panel
Check gap dimensions of wing and make adjustments if necessary.
>*** 5X00IN Gap dimensions
Remove front wing from front and rear wing connection panel.
Tighten screws -3- to > Tightening torque 10 (7.5 ftlb.) Nm > Tightening torque 10 (7.5 ftlb.) Nm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws
Clip in electric wire harness -1- (-2- ).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness
Install pressure sensor -2- and tighten screw -1- to > Tightening torque 8 (6 ftlb.) Nm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressure sensor