Removing Cover For Rear Underbody

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT:

The number of screws, clips, electric plug connections, holders and trim panels can vary depending on equipment.
The illustrations for removing and installing are shown only on one equipment variant and can differ from the actual equipment variant.
Some steps must be carried out automatically.

Remove rear underbody cover -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws on rear underbody cover
1. 1.1 Unscrew and remove screws -1- .
2. 1.2 Remove cover for rear underbody -2- .
Remove rear underbody cover at the centre -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear underbody cover, centre
1. 2.1 Screw off nut -2- .
2. 2.2 Remove expansion rivets -1- .
3. 2.3 Unscrew and remove screws -4- .
4. 2.4 Remove rear underbody cover at the centre -3- .
Remove rear underbody cover at the left -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws on rear underbody cover, left
1. 3.1 Unscrew and remove screws -2- .
2. 3.2 Remove expansion rivets -1- .
3. 3.3 Remove rear underbody cover at the left -3- .
Remove rear underbody cover at the right -4- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws on rear underbody cover, right
1. 4.1 Unscrew and remove screws -3- .
2. 4.2 Screw off nut -2- .
3. 4.3 Remove expansion rivet -1- .
4. 4.4 Remove rear underbody cover at the right -4- .