Subsequent Work

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

For centre underbody cover at the left:
Install side section of front underbody cover -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws for cover
1. 1.1 Move side section of front underbody cover -3- into installation position.
2. 1.2 Screw in screws -2- and tighten to > Tightening torque 3 N.m (2 ft.lb) . > Nr.89 Pos.5 - Torque screwdriver
Lower the vehicle.
4X00IN Lifting the vehicle