Preparing Outer Side Member (Rear Section) For Installation
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Fit in and secure outer side member (rear section) -C and E-
.
- 1.1 Cut outer side member (rear section) -C and E- at the points where it joins the body leaving an overlap of 30 mm.
- 1.2
Fit in outer side member (rear section) -C and E-
.
Possible separation poir ts on outer side member
- 1.3
Make cuts through the outer side member and body in the overlap areas -C and E-
.
Check gap dimensions.
Cuts through outer side member and body
- Punch holes for flow-form rivets in areas -B and C-
using > VAS 852 001 - dent removal unit
and > VAS 6790 - compact booster
.
5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS
Drilling area
- Remove outer side member (rear section).
- Cut sheetmetal inserts used as a welding backing strip for the weld areas from the old outer side member (rear section).
- Prepare connection areas > Outer side member (rear section)
for joining.
Outer side member (rear section)
Yellow Bonding and resistance spot-welding
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVEOrange Bonding and riveting
> 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE - Prepare connection areas > Outer side member (rear section)
for applying a full aluminum weld using inert gas.
Outer side member (rear section)
Yellow Applying full weld using inert gas (steel) Magenta Applying full aluminum veld using inert gas
> 5X00IN10 WELDING ALUMINIUM