Installation Position
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
Installation position
IMPORTANT:
Cuts can be made in defined areas in the outer side member due to the par ts dimensions. The purpose of the different cuts is to keep the repair area as small as possible in the event of damage.
The diagram should help you to detei mine the correct position of cuts.
Possible separation points on outer side member
A-B-C Replace cuts for outer side member
514555 Replacing outer side member
A-D Replace cuts for centre side member
51455503 REPLACING OUTER SIDE MEMBER (FRONT SECTION)
B-D-E Replace cuts for B-pillar reinforcement
514255 REPLACING B-PILLAR REINFORCEMENT
D-E Replace cuts for B-pillar
514155 REPLACING B-PILLAR
C-E Replace cuts for rear side member
51455505 REPLACING OUTER SIDE MEMBER (REAR SECTION)
The diagram should help you to detei mine the correct position of cuts.
Possible separation points on outer side member
A-B-C Replace cuts for outer side member
514555 Replacing outer side member
A-D Replace cuts for centre side member
51455503 REPLACING OUTER SIDE MEMBER (FRONT SECTION)
B-D-E Replace cuts for B-pillar reinforcement
514255 REPLACING B-PILLAR REINFORCEMENT
D-E Replace cuts for B-pillar
514155 REPLACING B-PILLAR
C-E Replace cuts for rear side member
51455505 REPLACING OUTER SIDE MEMBER (REAR SECTION)