Preparing Outer Side Member For Installation
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Fit and secure outer side member -A, B and C-
.
Possible separation points on outer side member
- 1.1 Cut outer side member -A, B and C- at the transitions to the body leaving an overlap of 30 mm.
- 1.2 Fit in outer side member -A, B and C- .
- 1.3
Make cuts through the outer side me mber and body in the overlap areas -A, B and C-
.
Check gap dimensions.
- Punch holes for flow-form rivets in areas -B-
using > VAS 852 001 - dent removal unit
and > VAS 6790 - compact booster
.
5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS
Bore holes for flow-form rivets
- Punch holes for flow-form rivets in areas -B-
using > VAS 852 001 - dent removal unit
and > VAS 6790 - compact booster
.
5X00IN23 REPLACING PUNCH RIVETS AND PENETRATED JOINTS
Bore holes for flow-form rivets
- Remove outer side member.
- Cut sheetmetal inserts used as a welding backing strip for the three weld areas from the old outer side member.
- Prepare connection areas > Outer side member
for bonding, riveting and resistance spot-welding.
5X00IN21 WORKING WITH BODY STRI ICTURAL ADHESIVE
Outer side member
Yellow Bonding and resistance spot-welding > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE Orange Bonding and riveting > 5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE - Prepare connection areas > Outer side member
for applying a full aluminum weld using inert gas.
Outer side member