LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (51 - Body Center, Roof, Frame 9YA) >> WM, 51455501 REPLACING outer SIDE MEMBER >> Installing Wing Fastening Rail

Installing Wing Fastening Rail

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Apply adhesive evenly over the entire bonding surface. 
IMPORTANT:
  • Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
  • The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
  • Do not begin bonding work until all materials and tools necessary for later repair work are available. 
  1. Install wing rail and check that it fits perfectly.
  2. Apply adhesive on joint areas of the body. > Application depth 0.5 mm 

    5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

    G14275595Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Wing rail

  3. Apply adhesive on joint areas of the body. > Application depth 0.5 mm 

    5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

    G14275596Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Preparing A-pillar

    1. 3.1  Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 
  4. Screw in self-tapping screws -1-  .

    5X00IN24 SETTING SELF-TAPPING SCREWS

    G14275597Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Self-tapping screws

scientia non olet · About LEMON Manuals