Preparing Connection Areas Of Body For Installing The A-Pillar
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Align the sealing surfaces and connections of the body.
- De-burr connection points and prepare them for joining.
- Prepare marked areas > Connection areas on A-pillar
for bonding and riveting.
5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE
Connection areas on A-pillar
- Prepare marked areas > Connection areas for bonding
for resistance spot-welding.
Connection areas for bonding
- Prepare connection areas > Connection areas for welding
for welding.
Connection areas for welding