Preparing Rear Cross Member For Installation
WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
- Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive.
- The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed.
- Do not begin bonding work until all materials and tools necessary for later repair work are available.
- Install rear cross member and secure it to the body.
- Drill bore holes for rivets > Punch rivets
through all sheetmetal panels. > Diameter 6.6 mm
Punch rivets
- Remove rear cross member.
- Prepare marked areas > Bonding areas
for bonding and riveting.
5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE
Bonding areas