LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2023 >> Cayenne Base, 4D Utility Coupe >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (51 - Body Center, Roof, Frame 9YA) >> WM, 510955 Replacing Rear Cross Member >> Installing Rear Cross Member

Installing Rear Cross Member

WARNING: This page is about a different car, the 2021 Porsche Cayenne, 2020 Porsche Cayenne, and 2019 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
  • Apply adhesive evenly over the entire bonding surface. 
IMPORTANT:
  • Before final assembly, make sure you fully understand all the work steps involved and carry out a trial assembly without applying adhesive. 
  • The bonding process can only be carried out reliably when a smooth and swift sequence of operations is guaranteed. 
  • Do not begin bonding work until all materials and tools necessary for later repair work are available. 
  1. Install rear cross member and check that it fits perfectly.
  2. Apply adhesive on joint areas > Bonding areas  of the body. > Application depth 0.5 mm 

    Use body structural adhesive.

    5X00IN21 WORKING WITH BODY STRUCTURAL ADHESIVE

    G14275201Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Bonding areas

  3. Apply adhesive on the rear cross member > Bonding areas.  > Application depth 0.5 mm 
    G14275202Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Bonding areas

    1. 3.1  Also apply a bead of adhesive all around the bonding surface. > Application depth 3 mm 
  4. Rivet in rear cross member. > BLIND RIVET 999.190.227.01 
scientia non olet · About LEMON Manuals