Removing Main Wire Harness In Passenger Compartment At The Rear
NOTIFICATION
Incorrect handling of main wire harness
- Risk of damage to lines
- → The main wire harness contains all airbag lines, antenna lines and optical waveguides.
- → The main wire harness must not be separated and is always replaced as a complete wire harness when carrying out extensive repairs.
- → If individual lines are damaged, shut off these lines and install new lines. Lay the new lines along the main wire harness and secure them to the main wire harness.
Information
The cutting ring -1- and Voss threaded joint -2- must remain on the air line -3- .
Air line
- Expose valve unit.
Valve unit
- 1.1 Loosen union nuts -1- , but do not unscrew fully until residual air has escaped.
- 1.2 Remove air lines from valve unit.
- 1.3 Close off all openings using suitable stoppers.
- Unclip line bracket -1-
for section of line for air suspension system.
Line bracket
- Release and disconnect electric plug connection for rear right angle sensor for headlight beam adjustment (HBA).
> 947919 REMOVING AND INSTALLING REAR ANGLE SENSOR FOR HEADLIGHT BEAM ADJUSTMENT (HBA)
- Release and disconnect electric plug connection for rear right air spring bellows.
- Unclip line bracket -1-
for section of line for rear axle.
Line bracket in rear axle area
- Guide wire harness with air lines -2-
on the rear axle forward.
Line bracket
- Press grommet -1-
inwards and lay section of line in the passenger compartment.
Sleeve
- Unclip line bracket -1-
for the fuel line and set the fuel line -2-
aside.
Fuel line
- Unclip line bracket -1-
for section of line for the fuel tank and set electric line -2-
down in the passenger compartment.
Line bracket
- Release and disconnect electric plug connection for fuel pump control unit.
- Lift up floor covering -1-
at the front left until the gateway control unit is accessible.
Carpet
- Release and disconnect electric plug connections -1-
on the gateway control unit.
Gateway control unit
- Unclip line bracket -1-
for section of line for the center console.
Line bracket
- Unclip line bracket -1-
for section of line for the passenger compartment at the left.
Line bracket
- Open clips -2-
for cable duct -1-
at the rear left door sill.
Left cable duct
- Lift up lining mat -1-
in the center tunnel until the cable duct is accessible.
Lining mat
- Open clips -2-
for cable duct -1-
at the center tunnel.
Cable duct on center tunnel
- Open clips -2-
for cable duct -1-
at the rear right door sill.
Right cable duct
- Unscrew fastening nut -1-
on ground point in the right footwell and remove ground lines -2-
.
Ground point in right footwell
- Cut tie-wrap -3-
on cable duct in the right footwell.
Cable duct
- Unclip electric plug connections -1-
at connection points for the seat.
Electric plug connections
- Unclip line bracket -2-
at connection points for the seat.
Electric plug connections
- Unclip line bracket -1-
and loosen wire harness for passenger compartment at the rear -2-
from the seat cross member.
Wire harness in passenger compartment, rear