Installing (Section From External Power Connection To Starter)
- Installation is performed in reverse order. Pay particular attention to the following:
Tighten fastening nut on line bracket to > Tightening torque 4 Nm (3 ftlb.) .
Tighten fastening screw on line bracket to > Tightening torque 4 Nm (3 ftlb.) .
Tighten fastening nut on external power connection to > Tightening torque 20 Nm (14.8 ftlb.) .
Tighten fastening nuts on starter to > Tightening torque 20 Nm (14.8 ftlb.) .
Tighten fastening screw on ground line to > Tightening torque 20 Nm (14.8 ftlb.) .