Applying Coating

Information 

• The hydrophobic coating must not come into contact with water or other fluids for at least 30 minutes after applying the coating. 

1. Apply hydrophobic coating agent as a flat liquid film and rub immediately and uniformly with a paper towel.
2. A grey fog forms on the treated surface following application. Polish off this grey fog completely using a new, dry and clean paper towel.
3. The coating must not come into contact with water or other fluids for at least 30 minutes.

   Dried-on coating agent can be softened by rubbing with the moist cloth and can then be rubbed off with a clean paper towel.