Removing Headliner
Information
Make sure that the roof cover does not buckle.
Information
- Some of the repair illustrations show only one side of the vehicle or a similar component.
- Naturally, some steps also have to be performed on the opposite side of the vehicle as well.
- Open covers -1-
and unscrew screws -2-
.
Covers
- Unclip headliner.
Headliner
- 2.1 Insert > VAS 6427 - release pliers -3- into the openings -2- on the clip. This actuates the tabs -1- on the clip and moves them inwards.
- Unclip electric lines -1-
from brackets -Arrows-
.
Electric lines for headliner
- Release and disconnect electric plug connection -1-
from the headliner -2-
.
Electric plug connection for headliner
- Move front seats all the way forward and down and move backrests back fully.
- Fold over rear seat.
Information
When removing the headliner, make sure to use a suitable tool as a support when unclipping it in the panoramic roof area.
- For vehicles with panoramic roof (3FU)
Unclip headliner -1- from retaining clips -2- in the panoramic roof aperture area.
Retaining clips on headliner
- Press clip -1-
together using two screwdrivers -Arrows-
and detach rear headliner from the body.
Headliner on body
Information
Three people are needed in order to remove the headliner.
- Position of 1st person: Driver's side.
- Position of 2nd person: Passenger's side.
- Position of 3rd person: Luggage compartment.
- Remove headliner -1-
Headliner
- 9.1 Lower the headliner -1- on the passenger's side as far as possible.
- 9.2 Pull the headliner -1- out towards the rear through the cut-out in the tailgate.