Removing Retaining Strip For Tail Light

Information 

• Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropanol. 
• Always use a clean cloth. 
• The room and object temperature must be at least +18°C. 
• Air humidity must be 40% - 60%. 

Installation is performed in reverse order. Pay particular attention to the following:

1. Position retaining strip under the outer tail light.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Gap from retaining strip to tail light

   1. 1.1 Align retaining strip using the gap dimension -Z-  shown.

      > Gap dimension 8 mm 

2. Position retaining strip under the inner tail light.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Gap from retaining strip to tail light

   1. 2.1 Align retaining strip using the gap dimension -Z-  shown.

      > Gap dimension 6 mm 

3. Position retaining strip at the side of the tail light.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Gap from retaining strip to tail light

   1. 3.1 Align retaining strip using the gap dimension -X -  shown.

      > Gap dimension 6 mm 

4. Fasten retaining strip -3-  :

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Retaining strip on tail light

   1. 4.1 Tighten nuts -1-  .

      > Tightening torque 4 Nm (3 ftlb.) 

   2. 4.2 Tighten screw -2-  .

      > Tightening torque 2.5 Nm (1.75 ftlb.)