Assembling Rear Apron

Information 

The pictures shown in this document may differ from the original.

1. Assembly is performed in reverse order. For ParkAssist (I-no. 7X5)  , pay particular attention to the following:
   1. 1.1 Clean bonding surface -1-  .

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Bonding surface

   2. 1.2 Pull protective film -1-  off the adhesive tape.

      Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Protective film on bonding surfaces

   3. 1.3 Affix parking sensor holders on the contour of the rear apron mounting and press on evenly using a suitable tool.