Removing Rear Apron
Information
- The number of screws, clips, plug connections, holders and trim panels can vary depending on equipment.
- The illustrations for removing and installing are shown only on one equipment variant and can differ from the actual equipment variant.
- Some of the repair illustrations show only one side of the vehicle.
- Unscrew screws -1-
from retaining frame.
Screws on retaining frame
- Unscrew rear screws -1-
from rear apron -2-
.
Screws on rear apron, rear
- Unscrew screws -1-
from heat shield -2-
.
Screws on heat shield
Information
Too much force can damage the component.
- Remove trim panel for tail light -1-
.
Tail light trim panel
- 4.1 Unclip locking lugs -2- .
- 4.2 Unclip tail light trim panel -1- by pulling it to the rear in direction of -Arrow- and carefully disengage the locking lugs -3- under the tail light.
- 4.3 Check locking lugs -2 and 3- for damage and replace tail light trim panel -1- if necessary.
- Unscrew screw -1-
and remove tailgate stop -2-
.
Tailgate stop
- Unscrew screw -1-
on frame for light.
Screw on frame for light
- Disconnect wire harness at the left -1-
.
Left wire harness
- 7.1 Release and unplug electric plug connection -2- .
- 7.2 Press grommet -3- through the body.
- 7.3 Unclip wire harness at the left -1- .
- 7.4 Guide wire harness at the left -1- through to the rear apron.
- Disconnect wire harness at the right -1-
.
Right wire harness
- 8.1 Release and unplug electric plug connections -2- .
- 8.2 Unclip wire harness at the right -1- .
- 8.3 Press grommet -3- through the body.
- 8.4 Guide wire harness at the right -1- through to the rear apron.
Information
The help of another person is required.
- Unclip rear apron -1-
on both sides by pulling it outwards -arrow A-
and to the rear -arrow B-
.
Rear apron
- Remove rear apron -1-
and place it in > VAS 6760 - storage system
.
Rear apron