Installing Cover For Rear Underbody
- Installation is performed in reverse order Pay particular attention to the following:
Tighten screws and nuts using > Nr.89 Pos.5 - torque screwdriver .
Screw in screws and tighten to > Tightening torque 3 Nm (2.2 ftlb.) .
Screw on nut and tighten to > Tightening torque 2 Nm (1.5 ftlb.) .
Screw on nut and tighten to > Tightening torque 2 Nm (1.5 ft lb. (+)
Screw in screws and tighten to > Tightening torque 2 Nm (1.5 ftlb.) .
Screw in screws and tighten to > Tightening torque 3 Nm (2.2 ftlb.) .
Screw in screws and tighten to > Tightening torque 2 Nm (1.5 ftlb.) .