Installing Cover For Front Underbody

Information 

Micro-self-locking screws 

Fit new screws following removal.

1. Installation is performed in reverse order. Pay particular attention to the following:

   Screw in fastening screws and tighten to > Tightening torque 3 Nm (2 ftlb.)  .

   Screw in new fastening screws and tighten to > Tightening torque 6 Nm (4.5 ftlb.)  .

   Screw in fastening screws and tighten to > Tightening torque 3 Nm (2 ftlb.)  .

   Screw in fastening screws and tighten to > Tightening torque 3 Nm (2 ftlb.)  .