Subsequent Work

Release and remove vehicle from the straightening system.
Clean joint areas and sheetmetal flanges with a wire brush.
Prime joint areas and sheetmetal flanges with 2K primer.
Restore standard seal using body sealant.
> 5X00IN CORROSION PROTECTION MEASURES DURING REPAIR WORK

Also seal the repair area carefully.
Paint repair area and adjacent surfaces, if necessary.
Restore standard underbody protection using underbody sealant.
> 5X00IN UNDERBODY PROTECTION
Apply standard cavity preservation.
> 5X00IN CAVITY PRESERVATION

Also carefully apply cavity preservation to the repair area.
Install removed accessories in the repair area.