Installing Front Side Member (Front Section)

Apply body structural adhesive evenly over the entire bonding surface. > Application depth 0.5 mm  >

Use body structural adhesive.

> 5X00IN WORKING WITH BODY STRUCTURAL ADHESIVE

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front side member (front section) - outer bonding surfaces

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front side member (front section) - inner bonding surfaces

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Inner bonding areas

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Inner bonding areas

1. 2.1  Apply body structural adhesive evenly over the entire bonding surface. > Application depth 0.5 mm  >
2. 2.2  Also apply a bead of adhesive on the front edge.

   > Application depth 3 mm  >

> 5X00IN24 SETTING SELF-TAPPING SCREWS

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws