Installing Front And Rear Wing Connection Panel

Position front and rear wing connection panel -1- on the wing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front and rear wing connection panel
Screw in screws -2- , but do not tighten.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws
Install front and rear wing connection panel -1- together with the front wing -2- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front and rear wing connection panel
Screw in screws -3- as far as required until the front and rear wing connection panels -1- can still be moved.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front and rear wing connection panel
Check gap dimensions of wing and make adjustments if necessary.
> 5X00IN GAP DIMENSIONS
Remove front wing from front and rear wing connection panel.
Tighten screws -3- to > Tightening torque 10 Nm (7.5 lb.) > Tightening torque 10 Nm (7.5 ftlb.) .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws
Clip in electric wire harness -1 (-2- ).

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness
Install pressure sensor -2- and tighten screw -1- to > Tightening torque 8 (6 lb.) Nm .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressure sensor