Assembling Lock Carrier

Information 

Check rubber buffer and replace if necessary.

1. Assembly is performed in reverse order. Pay particular attention to the following:

   For split lock carriers (off-road):

   Tighten screws securing lower part of lock carrier to upper part of lock carrier to > Tightening torque 9 Nm (6.6 lb.)  .

   For all vehicles:

   Tighten screws for coolant line to > Tightening torque 8 Nm (5.9  ftlb.) .

   Tighten screw on top of radiator mounting to > Tightening torque 8 Nm (5.9  ftlb.) .

   Tighten screws on side of radiator mounting to > Tightening torque 8 Nm (5.9  ftlb.) .