LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2022 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 81 (Collision*** 5X Body - General - Wagon -- 971 - PANAMERA (971)) >> 5X Body - General >> WM, 5X00IN22 Processing Body Foam Filler >> Processing Body Foam Filler >> Processing Conditions

Processing Conditions

WARNING: This page is about a different variant/trim than selected.

During processing, the ambient and material temperature must be at least > Minimum temperature 15°C  and must not exceed a maximum temperature of > Maximum temperature 28°C  .

Higher processing temperatures reduce processing time. Processing can be interrupted briefly for up to 5 minutes.

> Processing time at 15°C 20 min 

> Processing time at 28°C 15 min 

The chemical reaction is essentially complete after approx. 30 minutes. The hardened foam does not swell or shrink.

scientia non olet · About LEMON Manuals