Installing Front Seat
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
→ Always use new screws or nuts following removal.
→ Comply with instructions for repairs.
→ Observe specified tightening torques.
→ Carry out a visual inspection of parts used.
- Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for screws for front seat rail: > Tightening torque 50 Nm (37 ftlb.)
Tightening torque for screws for rear seat rail: > Tightening torque 50 Nm (37 ftlb.)