Tightening Sequence For Low-Pressure Fuel Lines
WARNING: This page is about a different variant/trim than selected.
- Fit union nut -1-
by hand.
- 1.1 Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting.
- Tighten screws -2-
.
> Tightening torque 9 Nm (6.5 ftlb.)
- Union nut -1-
> Initial tightening 8 Nm (6 ftlb.)
> Final tightening + 50°
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Tightening sequence for low-pressure fuel line