Installing Oil-Pressure Sender
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for oil-pressure sender: > Tightening torque 20 Nm (15 ftlb.)
Tightening torque for screws on cable duct: > Tightening torque 9 Nm (6.5 ftlb.)
Tightening torque for screw-type clamp for suction hose: > Tightening torque 3.5 Nm (2.5 ftlb.)