Removing Solenoid Hydraulic Valve For Valve Lift Adjustment (Cylinder 2)
WARNING: This page is about a different variant/trim than selected.
Only for intake side of cylinder 2:
- Remove partial load vent line for oil mist separator -2- .
- Lift up moulded part -2- .
- Unscrew fastening screws -1-
and remove solenoid hydraulic valve for valve lift adjustment -2-
.
Solenoid hydraulic valve for valve lift adjustment
Only for outlet side of cylinder 2:
- Remove partial load vent line for oil mist separator -2-
.
- 4.1 Press release buttons on both sides and loosen adapter -1- .
- 4.2 Remove partial load vent line -2- .
Partial load vent line
- Remove engine wire harness guide -2-
.
- 5.1 Unclip, release and disconnect electric plug connection -1- .
- 5.2 Open engine wire harness guide -2- and remove wire harness.
- 5.3 Screw off fastening nuts -3- .
- 5.4 Remove engine wire harness guide -2- .
Engine wire harness guide
- Lift up moulded part -2-
.
- 6.1 Release and disconnect electric plug connection -1- .
- 6.2 Lift up moulded part -2- for easier access to the solenoid hydraulic valve for valve lift adjustment.
Outlet side of cylinder 2
- Unscrew fastening screws -1- and remove solenoid hydraulic valve for valve lift adjustment -2- .
Solenoid hydraulic valve for valve lift adjustment